I need to take a few mm off some internal doors to get them to fit. Forgot your password? They were all original just too small, for the frames that were fitted.
Screws not done up tight etc etc. Now use a circular saw to make the cut, with the edge of the saw resting against the guide board. Share This Page Tweet. Dressing Up a Blank Backyard Feb 11, 2019.
Email will not be published required. Uneven gaps around the doors, rubbing the carpet. Some couldn't be closed at all.
Always remember that it is easier to cut more off your door than it is to add it back on. The panel will just fall right out.
Yalanovsky also writes a bimonthly column that provides home improvement advice. Systemmaster , Feb 8, 2013.
Yalanovsky, Dale. Tracy Wellman Says: IF necessary screw the frame to the wall to make it secure and to straighten it up if it needs it 5 Many doors have some sort of pattern, pannels or something.
I had a similar job to do recently and had about 5mm to take off, so as I don't have a table saw, fixed a straight guide on to the door and ran my circular saw along it - then finished with a normal hand planer.
Which carpenter, I thought!! Depends how many mm's you're taking off. Since they are hollow, some care needs to be taken when attempting to shorten them.